How do I fit the trigger sensor?

How do I fit the trigger sensor?

Our EFI and Ignition systems use the same custom sensor and sensor mounting.

Fitting and alignment are simple to carry out.

A printable template is provided that allows you to easily check the alignment of the sensor prior to installing the crank pulley and trigger wheel.

Full instructions are provided in the documentation.

    • Related Articles

    • How do I fit the trigger sensor?

      Our EFI and Ignition systems use the same custom sensor and sensor mounting. Fitting and alignment are simple to carry out. The trigger wheel is zinc plated 3mm steel and is designed to fit the rear of an aftermarket style pulley. The pulley will ...
    • How do I fit this to a single-port?

      The standard manifold diameter supplied will fit the standard 1600 dual-port end castings. If you have an earlier 40 horse engine (single-port) you can order the kit with a smaller diameter manifold. This then allows you to cut your existing manifold ...
    • Is the ECU pre-programmed?

      All of our ECUs are shipped pre-programmed and bench tested. If you have purchased an ignition or EFI kit, the ECU is tested along with the loom and sensors, essentially as it would be installed in your car. Crank pulleys and crank  trigger sensors ...
    • Ignition control

      When running one of our supercharger kits you will need to consider how to control your ignition timing. The method used will largely be driven by the performance level that you are targeting. Higher boost levels require better and more accurate ...
    • Which of your kits permit to close the engine deck lid?

      The following products fit under the stock decklid on a VW Beetle AMR500 Budget kits AMR500 Side-draft kits if used with an S&S Carburettor AMR500 Dual blow through kits AMR500 Vintage kit (just) Centrifugal blower kits