How do I fit the trigger sensor?

How do I fit the trigger sensor?

Our EFI and Ignition systems use the same custom sensor and sensor mounting.

Fitting and alignment are simple to carry out.

The trigger wheel is zinc plated 3mm steel and is designed to fit the rear of an aftermarket style pulley. The pulley will need to have a recess machined into it to accept the trigger wheel. This can be carried out by any machine shop or if you have access to a lathe is easy to carry out yourself. We will fit this for free if purchasing with one of our blower kits. Full instructions are available in the support section on purchase.

The trigger sensor simply bolts to the existing case stud behind the crank pulley in the engine bay. There is no need to remove or modify tin-wear

Initial sensor alignment is easily achieved using our sensor alignment template which is available to download with your purchase

Trigger angle settings and electrical connections for your ECU are also included.

    • Related Articles

    • How do I fit the trigger sensor?

      Our EFI and Ignition systems use the same custom sensor and sensor mounting. Fitting and alignment are simple to carry out. A printable template is provided that allows you to easily check the alignment of the sensor prior to installing the crank ...

    • How do I fit this to a single-port?

      The standard manifold diameter supplied will fit the standard 1600 dual-port end castings. If you have an earlier 40 horse engine (single-port) you can order the kit with a smaller diameter manifold. This then allows you to cut your existing manifold ...

    • Is the ECU pre-programmed?

      All of our ECUs are shipped pre-programmed and bench tested. If you have purchased an ignition or EFI kit, the ECU is tested along with the loom and sensors, essentially as it would be installed in your car. Crank pulleys and crank  trigger sensors ...

    • Which of your kits permit to close the engine deck lid?

      The following products fit under the stock decklid on a VW Beetle AMR500 Budget kits AMR500 Side-draft kits if used with an S&S Carburettor AMR500 Dual blow through kits AMR500 Vintage kit (just) Centrifugal blower kits

    • Remote dashboard apps

      We recommend MS Droid as the best allround remote dash app to use with our products. http://www.msdroid.com/ MS Droid offers user editable screen layouts which can be custom configured for landscape and portrait orientation. You can also combine ...